Features at a glance
-	Handles slopes up to 1:3 (35%)
-	Battery Life is 1-3 years depending on size of lawn, length of season and grass growth rate.
-	Blade life on large areas is 1-2 months (longer on small areas)
-	Replacement cost is approximately $5 for a new set of blades.
-	Mows in the rain
-	Safe in yards with pets.
-	The Automower will cut as rough or bumpy an area as a conventional walk behind mower.
-	Leaves 6" to trim along edges
-	Energy consumption at max capacity - 15 kWh / month for the 220AC - 20 kWh / month for the 230ACx
-	Height settings from 1 1/2" to 3"
-	Lift sensor stops the blades within 2 seconds if lifted off the ground.
-	Installation takes 2 - 5 hours depending on the yards complexity
-	Multiple zones can be programmed as well as the percentage of time spent in each one.
-	Automower has a 2 year warranty /  1 year on battery
-	Built with stainless steel components to prevent corrosion and wear

Call us toll free 877.428.1546 Or email for more information on the Husqvarna Automower

Function of Automower™
Capacity
Automower is recommended for lawns up to 0.75 acres (0.50 acres for 220 AC). How large an area is mown depends primarily on the condition of the blades and the type of grass, growth rate and humidity. The shape of the garden is also significant. If the garden mainly consists of open lawns, Automower can mow more per hour than if the garden consists of several small lawns separated by trees, flower beds and passages. How long Automower mows and recharges can vary depending on, among others, the ambient temperature. Up to about 77° F a fully charged Automower mows for approximately 60 - 90 minutes, (40 - 60 minutes for 220 AC), depending on the age of the battery and the thickness of the grass. The mower then charges for 45 - 60 minutes. Above 77° F both the mowing and charging times gradually drop.

Mowing technique
The mowing system used by Automower is based on an effective and energy efficient principle. Unlike normal lawn mowers, Automower cuts the grass instead of striking it off. We recommend you allow Automower to mainly mow in dry weather to obtain the best possible result. Automower can even mow in the rain, however, wet grass easily collects on the mower and the risk of slipping on steep slopes is greater. When there is a risk of thunder Automower should not stand in the charging station. When there is a risk of a thunder storm, the 120 V plug should be removed from the main socket and the boundary wire disconnected from the charging station. The blades must be in good condition to obtain the best mowing result. In order to keep the blades sharp for as long as possible it is important to keep the lawn free from branches, small stones and other objects.

Working method
Automower automatically mows the lawn. It continuously combines mowing and charging. The charging station sends out a signal that Automower can sense at a distance of 20 -23 feet. The mower starts to search for the charging station when the battery charge becomes too low. Automower does not mow when it is searching for the charging station. When Automower searches for the charging station it uses one or more of three different search methods: Irregular, Follow boundary wire and Follow guide wire. When the battery is charged the mower reverses, turns around and leaves the charging station in a randomly selected direction within the exit sector 90° - 270°. To make it easier for Automower to reach all parts of the garden you can manually set how the mower will leave the charging station. When  Automower body hits an obstacle, the mower reverses and selects a new direction. Two sensors, at the front and back on Automower, sense when the mower approaches the boundary wire. Automower overruns the wire by up to 10.5 inches before it turns.
Available as an accessory is a weatherproof shelter for the docking station.

Movement pattern
The mower’s movement pattern is irregular and is determined by Automower itself. A movement pattern is never repeated. This mowing system means the lawn is mown equally without any mowing lines. If Automower enters an area where it senses the grass is longer than earlier, it can change the movement pattern. It can then mow in a square pattern to cover the area of longer grass more systematically. When Automower mows in a square pattern, this is known as square mode cutting. The mower must have been operational for more than 6 hours in order for Automower to start square mode cutting.

The Boundary Wire
The boundary wire should not be laid across a slope that is steeper than 10%. There is a risk of Automower finding it difficult to turn there. The mower will then stop and show the fault message Outside working area. The risk is at its greatest in damp weather conditions, as the wheels can slip on the wet grass. However, the boundary wire can be laid across a slope steeper than 10% when there is an obstacle that Automower can be permitted to collide with, for example, a fence or a dense hedge. Automower can mow areas inside the working area that slope up to 14 inches per distance meter (35%). Areas that slope more must be demarcated by the boundary wire. When any part of the working area's boundary slopes more than 4 inches per distance meter (10%), the boundary wire must be routed about 14 inches on flat ground before the slope starts.

Adjusting the cutting height
The cutting height can be varied from MIN (0.8 in) to MAX (2.5 in). If the grass is long it is appropriate to let Automower start mowing at the MAX cutting height. Once the grass is shorter, you can gradually lower the cutting height.

Control panel
All forms of commands and settings for the  Husqvarna Automower™ are made via the control panel. All functions are accessed via a number of menus.

Programs
Under the program buttons you can save sets of different settings, to reuse or to simplify the use of Automower in several gardens. Under respective buttons there are some preset settings. You can choose to use these or change them.

Timer
Your lawn should not be cut too often to obtain the best mowing result. Consequently, it is important to limit the operating time using the timer function if the working area is less than the mower's working capacity. When Automower is allowed to mow too much, the lawn may appear flattened. Besides, the mower is subjected to unnecessary wear. The timer function is also an ideal means to control during which periods Automower should not mow, for example, when the children are playing in the garden.